User manual

www.ti.com AUX – Sensor Controller Registers
17.8.3.10 EVTOMCUPOL Register (Offset = 24h) [reset = X]
EVTOMCUPOL is shown in Figure 17-29 and described in Table 17-49.
Event To MCU Domain Polarity AUX event source polarity for the event flags to the MCU domain Note the
inverse polarity (0 = high, 1 = low).
Figure 17-29. EVTOMCUPOL Register
31 30 29 28 27 26 25 24
RESERVED
R-X
23 22 21 20 19 18 17 16
RESERVED
R-X
15 14 13 12 11 10 9 8
RESERVED ADC_IRQ OBSMUX0 ADC_FIFO_AL
MOST_FULL
R-X R/W-X R/W-X R/W-X
7 6 5 4 3 2 1 0
ADC_DONE SMPH_AUTOT TIMER1_EV TIMER0_EV TDC_DONE AUX_COMPB AUX_COMPA AON_WU_EV
AKE_DONE
R/W-X R/W-X R/W-X R/W-X R/W-X R/W-X R/W-X R/W-X
Table 17-49. EVTOMCUPOL Register Field Descriptions
Bit Field Type Reset Description
31-11 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
10 ADC_IRQ R/W X
Selects the event source level that sets
EVTOMCUFLAGS.ADC_IRQ.
0h = High level
1h = Low level
9 OBSMUX0 R/W X
Selects the event source level that sets
EVTOMCUFLAGS.OBSMUX0.
0h = High level
1h = Low level
8 ADC_FIFO_ALMOST_FU R/W X
Selects the event source level that sets
LL
EVTOMCUFLAGS.ADC_FIFO_ALMOST_FULL.
0h = High level
1h = Low level
7 ADC_DONE R/W X
Selects the event source level that sets
EVTOMCUFLAGS.ADC_DONE.
0h = High level
1h = Low level
6 SMPH_AUTOTAKE_DON R/W X
Selects the event source level that sets
E
EVTOMCUFLAGS.SMPH_AUTOTAKE_DONE.
0h = High level
1h = Low level
5 TIMER1_EV R/W X
Selects the event source level that sets
EVTOMCUFLAGS.TIMER1_EV.
0h = High level
1h = Low level
4 TIMER0_EV R/W X
Selects the event source level that sets
EVTOMCUFLAGS.TIMER0_EV.
0h = High level
1h = Low level
1249
SWCU117A–February 2015–Revised March 2015 AUX – Sensor Controller with Digital and Analog Peripherals
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated