User manual

AUX – Sensor Controller Registers www.ti.com
17.8.3.3 SCEWEVSEL Register (Offset = 8h) [reset = X]
SCEWEVSEL is shown in Figure 17-22 and described in Table 17-42.
Sensor Controller Engine Wait Event Selection Event selection for the AUX_SCE WEV0, WEV1, BEV0
and BEV1 instructions
Figure 17-22. SCEWEVSEL Register
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
RESERVED
R-X
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
RESERVED WEV7_EV
R-X R/W-X
Table 17-42. SCEWEVSEL Register Field Descriptions
Bit Field Type Reset Description
31-5 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
4-0 WEV7_EV R/W X
Selects the event source to be mapped to
AUX_SCE:WUSTAT.EV_SIGNALS bit 7.
0h = AON_RTC_CH2 event
1h = AUX_COMPA event
2h = AUX_COMPB event
3h = TDC_DONE event
4h = TIMER0_EV event
5h = TIMER1_EV event
6h = SMPH_AUTOTAKE_DONE event
7h = ADC_DONE event
8h = ADC_FIFO_ALMOST_FULL event
9h = OBSMUX0 event
Ah = OBSMUX1 event
Bh = AON_SW event
Ch = AON_PROG_WU event
Dh = AUXIO0 input data
Eh = AUXIO1 input data
Fh = AUXIO2 input data
10h = AUXIO3 input data
11h = AUXIO4 input data
12h = AUXIO5 input data
13h = AUXIO6 input data
14h = AUXIO7 input data
15h = AUXIO8 input data
16h = AUXIO9 input data
17h = AUXIO10 input data
18h = AUXIO11 input data
19h = AUXIO12 input data
1Ah = AUXIO13 input data
1Bh = AUXIO14 input data
1Ch = AUXIO15 input data
1Dh = ACLK_REF event
1Eh = MCU_EV event
1Fh = ADC_IRQ event
1242
AUX – Sensor Controller with Digital and Analog Peripherals SWCU117A–February 2015–Revised March 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated