User manual

www.ti.com

Cortex-M3 Processor Registers

2.7.2.16 MASK2 Register (Offset = 44h) [reset = X]

MASK2 is shown in Figure 2-56 and described in Table 2-80.

Mask 2 Use the DWT Mask Registers 2 to apply a mask to data addresses when matching against

COMP2.

Figure 2-56. MASK2 Register

31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

RESERVED MASK

R/W-X R/W-0h

Table 2-80. MASK2 Register Field Descriptions

Bit Field Type Reset Description

31-4 RESERVED R/W X

Software should not rely on the value of a reserved. Writing any

other value than the reset value may result in undefined behavior.

3-0 MASK R/W 0h

Mask on data address when matching against COMP2. This is the

size of the ignore mask. That is, DWT matching is performed

as:(ADDR ANDed with (0xFFFF left bit-shifted by MASK)) ==

COMP2. However, the actual comparison is slightly more complex to

enable matching an address wherever it appears on a bus. So, if

COMP2 is 3, this matches a word access of 0, because 3 would be

within the word.

111

SWCU117A–February 2015–Revised March 2015

Submit Documentation Feedback