User manual

General-Purpose Timer Registers www.ti.com
13.5.1.9 ICLR Register (Offset = 24h) [reset = X]
ICLR is shown in Figure 13-17 and described in Table 13-16.
Interrupt Clear This register is used to clear status bits in the RIS and MIS registers
Figure 13-17. ICLR Register
31 30 29 28 27 26 25 24
RESERVED
R-X
23 22 21 20 19 18 17 16
RESERVED WUECINT
R-X R/W1C-X
15 14 13 12 11 10 9 8
RESERVED DMABINT RESERVED TBMCINT CBECINT CBMCINT TBTOCINT
R-X R/W1C-X R/W-X R/W1C-X R/W1C-X R/W1C-X R/W1C-X
7 6 5 4 3 2 1 0
RESERVED DMAAINT TAMCINT RTCCINT CAECINT CAMCINT TATOCINT
R-X R/W1C-X R/W1C-X R/W1C-X R/W1C-X R/W1C-X R/W1C-X
Table 13-16. ICLR Register Field Descriptions
Bit Field Type Reset Description
31-17 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
16 WUECINT R/W1C X
0: Do nothing. 1: Clear RIS.WURIS and MIS.WUMIS
15-14 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
13 DMABINT R/W1C X
0: Do nothing. 1: Clear RIS.DMABRIS and MIS.DMABMIS
12 RESERVED R/W X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
11 TBMCINT R/W1C X
0: Do nothing. 1: Clear RIS.TBMRIS and MIS.TBMMIS
10 CBECINT R/W1C X
0: Do nothing. 1: Clear RIS.CBERIS and MIS.CBEMIS
9 CBMCINT R/W1C X
0: Do nothing. 1: Clear RIS.CBMRIS and MIS.CBMMIS
8 TBTOCINT R/W1C X
0: Do nothing. 1: Clear RIS.TBTORIS and MIS.TBTOMIS
7-6 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
5 DMAAINT R/W1C X
0: Do nothing. 1: Clear RIS.DMAARIS and MIS.DMAAMIS
4 TAMCINT R/W1C X
0: Do nothing. 1: Clear RIS.TAMRIS and MIS.TAMMIS
3 RTCCINT R/W1C X
0: Do nothing. 1: Clear RIS.RTCRIS and MIS.RTCMIS
2 CAECINT R/W1C X
0: Do nothing. 1: Clear RIS.CAERIS and MIS.CAEMIS
1 CAMCINT R/W1C X
0: Do nothing. 1: Clear RIS.CAMRIS and MIS.CAMMIS
0 TATOCINT R/W1C X
0: Do nothing. 1: Clear RIS.TATORIS and MIS.TATOMIS
1102
Timers SWCU117A–February 2015–Revised March 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated