User manual

www.ti.com I/O Control Registers
11.11.3.5 DOUT19_16 Register (Offset = 10h) [reset = X]
DOUT19_16 is shown in Figure 11-44 and described in Table 11-48.
Data Out 16 to 19 Alias register for byte access to each bit in DOUT31_0
Figure 11-44. DOUT19_16 Register
31 30 29 28 27 26 25 24
RESERVED DIO19
R-X W-X
23 22 21 20 19 18 17 16
RESERVED DIO18
R-X W-X
15 14 13 12 11 10 9 8
RESERVED DIO17
R-X W-X
7 6 5 4 3 2 1 0
RESERVED DIO16
R-X W-X
Table 11-48. DOUT19_16 Register Field Descriptions
Bit Field Type Reset Description
31-25 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
24 DIO19 W X
Sets the state of the pin that is configured as DIO#19, if the
corresponding DOE31_0 bitfield is set.
23-17 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
16 DIO18 W X
Sets the state of the pin that is configured as DIO#18, if the
corresponding DOE31_0 bitfield is set.
15-9 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
8 DIO17 W X
Sets the state of the pin that is configured as DIO#17, if the
corresponding DOE31_0 bitfield is set.
7-1 RESERVED R X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
0 DIO16 W X
Sets the state of the pin that is configured as DIO#16, if the
corresponding DOE31_0 bitfield is set.
1017
SWCU117A–February 2015–Revised March 2015 I/O Control
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated