User Manual

Table Of Contents

Figure2. Bottom view of CC2564MODNEM

Interface highlights:

1. U5: CC2564MODN SIP module.

2. P3: U.FL connector let RF signal in/out path, which R30 need tie on 0ohm.

3. J4: VBAT_MCU: 3V3 for main system power path form RF2.

4. J3: VBAT_EDGE: 3V3 for main system power path form P2

5. J2&R10: VBAT_CC: 3V3 for CC2564MODN main power

6. J1&R7: VDO_1V8: V8 for system IO level path

7. RF1&RF2&P2: For TI’s experimenter board IO used.

AMPAK Technology Inc. www.ampak.com.tw Proprietary & Confidential Information

Doc. NO: