Datasheet

BUF16821EVM-USB Software Overview

www.ti.com

5.2 Using the BUF16821Software

5.2.1 I

C Address Selection

As mentioned previously in the BUF16821EVM-USB Features section (see Section 3.7), jumper JMP5 is

used to set the I

C address pin of the BUF16821. Figure 15 shows how both the hardware and software

must be set to allow for communication between the BUF16821EVM-USB and the software. Without

jumper JMP5 and the software address button configured correctly, the software will not be able to

communicate with the BUF16821 device.

Figure 15. JMP5 Setting For Logic ‘1’

When JMP5 and the software are set as Figure 16 shows, the second I

C address can be configured.

Figure 16. JMP5 Setting for Logic ‘0’

BUF16821EVM-USB Evaluation Board and Software Tutorial SBOU106– May 2011

Submit Documentation Feedback