Datasheet

BUF08832EVM Software Overview

www.ti.com

5.2 Using the BUF08832 Software

5.2.1 I

C Address Selection

As mentioned previously in the BUF08832_Test_Board Features section (see Section 3.7), jumper JMP1

is used to set the I

C address pin of the BUF08832. Figure 15 shows how the hardware and software

must both be set to allow for communication between the BUF08832EVM and the software. Without

jumper JMP1 and the software address button configured correctly, the software will not be able to

communicate with the BUF08832 device.

Figure 15. BUF08832_Test_Board Jumper JMP1 Set For Logic ‘1’

When JMP1 and the software are set as shown in Figure 16, the second I

C address can be configured.

Figure 16. BUF08832_Test_Board Jumper JMP1 Set For Logic ‘0’

BUF08832EVM User Guide and Software Tutorial SBOU081–November 2009

Submit Documentation Feedback