Datasheet

BUF08821EVM-USB Hardware Overview

www.ti.com

3.6 BUF08821EVM-USB Default Jumper Settings

Figure 9 shows the default jumpers configuration for the BUF08821EVM-USB. In general, the jumper

settings of the USB_DIG_Platform will not need to be changed. You may want to change some of the

jumpers on the BUF08821EVM-USB board to match your specific configuration. For instance, you may

wish to set a specific I

C address on the DUT.

Figure 9. BUF08821EVM-USB Default Jumper Settings

Jumpers 1 through 5 on the BUF08821EVM-USB are all typically set to the same position. When set to

the INT position, the signals from the digital supply, bank select, and the digital communication lines are

generated and controlled from the USB_DIG_Platform or by the onboard bank select switch. When these

jumpers are set to the EXT position, the previously described signals connect to the terminal strips T2, T3,

and T4. Jumper 5 controls the I

C address pin for the BUF08821. This jumper can set the address for A0

to either high or low.

BUF08821EVM-USB User Guide and Software Tutorial SBOU095–March 2011

Submit Documentation Feedback