Datasheet

EPROM Programming Procedures www.ti.com
4. Run bq76PL536 OTP EPROM Programmer Software.
5. Load the image created with bq76PL536EVM ( Figure 7 and Figure 8).
6. Insert the integrated circuit (IC) into the socket. Check for pin 1 orientation. See Figure 10. The 22V
and 7V LEDs must be on. If not, press the F2 function key, "Connect to Dongle". See Figure 21.
7. Test the IC. Click the Click to Detect selection.
8. Separate pass and fail IC.
9. Insert a new IC, and repeat from step 5.
10. See Figure 9 to Figure 13 for complete sequence of EPROM programming.
Figure 3. Setting Trimming Value
Figure 4. Creating Programmable Image
4
bq76PL536PGM-1 Programming Board SLUU468–December 2010
Submit Documentation Feedback
© 2010, Texas Instruments Incorporated