Datasheet

www.ti.com EPROM Programming Procedures
Figure 1. bq76PL536EVM-3
3.2 Connecting bq76PL536PGM
Figure 2. bq76PL536PGM-1
1. Connect the USB cable to the Aardvark adapter and your PC.
2. Connect the Aardvark ribbon cable to the 10-pin header on the bq76PL536PGM programmer board.
3. Run the bq76PL536 OTP EPROM programmer software on your PC.
4. Check for 22-V and 7-V LEDs on the board and GUI. See Figure 9.
5. If all of the LEDs are not ON, select Connect to Dongle (F2), or repeat the preceding steps.
4 EPROM Programming Procedures
1. Set EPROM trimming values.
(a) Set up bq76PL536EVM-3. See Section 3 or the bq76PL536EVM-3 user's guide.
(b) Set trimming values. See Figure 3.
2. Create programmable image.
(a) Create program image ( Figure 4).
(b) Enter information on optional product data ( Figure 5).
(c) Save image file in YYYYYY.xml format ( Figure 6).
(d) Save the YYYYYY.xml file to a directory.
3. Connect the Aardvark adapter to the bq76PL536PGM-1 programming board. See Section 3.
3
SLUU468–December 2010 bq76PL536PGM-1 Programming Board
Submit Documentation Feedback
© 2010, Texas Instruments Incorporated