Datasheet

bq76PL536A

www.ti.com

SLUSAD3A –JUNE 2011–REVISED AUGUST 2012

1 = The internal consistency check has failed self-test. The host should attempt to reset

the device, see the RESET section. If the fault persists, the failure should be

considered uncorrectable.

[4] (FORCE): This bit asserts the FAULT signal. It can be used to verify correct operation and

connectivity of the FAULT line as a part of system self-test.

0 = Deassert FAULT (default)

1 = Assert the FAULT signal.

[3] (POR): This bit indicates a power-on reset (POR) has occurred.

0 = No POR has occurred since this bit was last cleared by the host.

1 = A POR has occurred. This notifies the host that default values have been loaded to

Group1 and Group2 registers, and OTP contents have been copied to Group3

registers.

[2] (CRC): This bit indicates a garbled packet reception by the device.

0 = No errors

1 = A CRC error was detected in the last packet received.

[1] (CUV): This bit indicates that this bq76PL536A has detected a cell undervoltage (CUV) condition.

Examine CUV_FAULT[] to determine which cell caused the ALERT.

0 = All cells are above the CUV threshold (default).

1 = One or more cells is below the CUV threshold.

[0] (COV): This bit indicates that this bq76PL536A has detected a cell overvoltage (COV) condition.

Examine COV_FAULT[] to determine which cell caused the FAULT.

0 = All cells are below the COV threshold (default).

1 = One or more cells is above the COV threshold.

COV_FAULT REGISTER (0x22)

7 6 5 4 3 2 1 0

– – OV[6] OV[5] OV[4] OV[3] OV[2] OV[1]

[0..5] (OV[1]..[6]): These bits indicate which cell caused the DEVICE_STATUS[COV] flag to be set.

0 = Cell[n] does not have an overvoltage fault (default).

1 = Cell[n] does have an overvoltage fault.

CUV_FAULT REGISTER (0x23)

7 6 5 4 3 2 1 0

– – UV[6] UV[5] UV[4] UV[3] UV[2] UV[1]

b0..5 (UV[1]..[6]): These bits indicate which cell caused the DEVICE_STATUS[CUV] flag to be set.

0 = Cell[n] does not have an undervoltage fault (default).

1 = Cell[n] does have an undervoltage fault.

PARITY_H REGISTER (0x24) (PRESULT_A (R/O))

7 6 5 4 3 2 1 0

OTT OTV CUVT CUVV COVT COVV IO FUNC

Product Folder Links :bq76PL536A