Datasheet

www.ti.com

Circuit Module Physical Layouts and Bill of Materials

Notes:

1. These assemblies are ESD sensitive: ESD precautions shall be observed.

2. These assemblies must be clean and free from flux and all contaminants. Use of no clean flux is not

acceptable.

3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.

4. Ref designators marked with an asterisk ('**') cannot be substituted.

All other components can be substituted with equivalent MFG's components.

5. Make one SMBus connector wire assembly for each assembly produced, from J1 mate, 4 - 24 Awg wires and

Crimp terminals. Wire colors for Pin numbers are listed below. The wire assembly shall have a J1 mate on each

end.

Red - Pin # 4 (Signal USB_5V)

Brown - Pin # 3 (Signal SDA)

White - Pin # 2 (Signal SCL)

Black - Pin # 1 (GND)

SLUU494–February 2011 bq28400EVM-001 SBS 1.1 Compliant Tablet PC and Netbook 2-Series Cell

Li-Ion Battery Gas Gauge and Protection

Submit Documentation Feedback