Datasheet

www.ti.com

Test Summary

2 Test Summary

This procedure describes one test configuration of the HPA759 evaluation board for bench evaluation.

2.1 Definitions

The following naming conventions are followed.

VXXX : External voltage supply name (VADP, VBT, VSBT)

LOADW: External load name (LOADR, LOADI)

V(TPyyy): Voltage at internal test point TPyyy. For example, V(TP12) means the voltage at

TP12.

V(Jxx): Voltage at header Jxx

V(TP(XXX)): Voltage at test point XXX. For example, V(ACDET) means the voltage at the test

point which is marked as ACDET.

V(XXX, YYY): Voltage across point XXX and YYY.

I(JXX(YYY)): Current going out from the YYY terminal of header XX.

Jxx(BBB): Terminal or pin BBB of header xx.

JPx ON : Internal jumper Jxx terminals are shorted.

JPx OFF: Internal jumper Jxx terminals are open.

JPx (-YY-) ON: Internal jumper Jxx adjacent terminals marked as YY are shorted.

Measure: → A, B Check specified parameters A, B. If measured values are not within specified limits,

the unit under test has failed.

Observe → A, B Observe if A, B occur. If they do not occur, the unit under test has failed.

Assembly drawings have locations for jumpers, test points, and individual components.

SLUU916–April 2012 WCSP-Packaged bq24272/273 Evaluation Modules

Submit Documentation Feedback