Datasheet

Bill of Materials
3-4
3.3 Bill of Materials
This section contains the bill of materials for the SLUP141.
Table 3–1 lists materials required for the DM2014H.
Table 3–1.Bill of Materials for SLUP141–bq2420xEVM
RefDes Count Description Size MFR Part Number Area
C1
1
Capacitor, ceramic, 0.1 µF,
16 V, X7R
805 Panasonic ECJ–2VB1C104K 10560
C2 1 Capacitor, ceramic,
0.47 µF, 16 V, X7R
805 Panasonic ECJ–2YB1C474K 10560
D1 1 Diode, Schottky, 1000 mA,
40 V
SOT23 Vishay–Liteon ZHCS1000 14105
J1, J5 2 Terminal block, 2 pin, 6 A,
3,5 mm
75525 OST ED1514 6/21/00 21:46
J2 1 Header, 2 pin, 100-mil
spacing, (36-pin strip)
23100 Sullins PTC36SAAN 6/21/00 21:46
J3 1 Header, 3 pin, 100-mil
spacing, (36-pin strip)
34100 Sullins PTC36SAAN 6/21/00 21:46
J4 1 Terminal block, 4 pin, 6 A,
3,5mm
148400 OST ED1516 6/21/00 21:46
R1, R2, R4 3 Resistor, chip, 1 kΩ,
1/10–W, 1%
805 Std Std 10560
R3 0 Resistor, chip, 2.0 Ω, 1 W,
1%
2512 WSL-2512-xx
1% R86
35100
R5, R6 2 Resistor, chip, 1 MΩ, 1/10
W, 1%
805 Std Std 10560
R7 0 Resistor, NOT USED OR
NEEDED
603 Std Std 5650
R8 1 Resistor, chip, 10 Ω,
1/16–W, 1%
603 Std Std 5650
U1 1 Diode, LED, Bicolor,
Green/Red, 20 mA, 25/40
mcd
24360 Chicago
Miniature
CMD67–22SRUGC
U2 1 IC, charge management,
linear Li-Ion, .5 A, 13 V
VCC max., 4.2 Vreg
DGN8 TI bq24200DGN 35250
PWB 1 PWB, SLUP141 (bq2420x) 6/21/00 21:46
Notes: 1) These assemblies are ESD-sensitive; observe ESD precautions.
2) These assemblies must be clean and free from flux and all contaminants. Use of no-clean flux is not acceptable.
3) These assemblies must comply with workmanship standards IPC–A–610 Class 2.
3.4 Reference
1) bq2420x data sheet, literature number SLUS501A