Datasheet

www.ti.com
5 List of Materials
List of Materials
Table 3 lists the materials required for the bq24081EVM.
Table 3. bq24081 EVM Parts List
(1)
Count Ref. Designator Value Description Size Part Number Manufacturer
2 C1, C2 1uF Capacitor, Ceramic, 1uF, 16-V, X7R 0805 (std) (std)
1 D1 Red Diode, LED, Red, 1.8-V, 20-mA, 20-mcd 0603 160-1181-1-ND Liteon
1 D2 Green Diode, LED, Green, 2.1-V, 20-mA, 6-mcd 0603 160-1183-1-ND Liteon
1 J1 Terminal Block, 2-pin, 6-A, 3.5mm 0.27 x 0.25 ED1514 OST
1 J2 Terminal Block, 4-pin, 6-A, 3.5mm 0.55 x 0.25 ED1516 OST
3 JPM1, JPM2, JPM3 PTC36SAAN Header, 2-pin, 100mil spacing, (36-pin strip) 0.100 inch x 2 PTC36SAAN Sullins
3 R1, R2, R6 1.5k Resistor, Chip, 1.5k-Ohms, 1/16-W, 1% 0603 Std Std
1 R3 1.13k Resistor, Chip, 1.13k-Ohms, 1/16-W, 1% 0603 Std Std
0 R5 0603
2 R4, R7 10k Resistor, Chip, 10k-Ohms, 1/16-W, 1% 0603 Std Std
1 U1 bq24081DRC IC, Single Chip, Li Ion/Li POL, Charger DRC10 bq24081DRC TI
1 -- PCB, 2 In x 1 In x 0.031 In HPA182 Any
(1)
Notes:
1. These assemblies are ESD sensitive, ESD precautions shall be observed.
2. These assemblies must be clean and free from flux and all contaminants. Use of no clean flux is not acceptable.
3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.
4. Ref designators marked with an asterisk ('**') cannot be substituted. All other components can be substituted with
equivalent MFG's components.
8 bq24081EVM 1-A Single-Chip Li-Ion and Li-Pol Charge SLUU261 – September 2006
Management IC Evaluation Module
Submit Documentation Feedback