Datasheet

www.ti.com
4.3 Bill of Materials
Schematic, Physical Layouts, and Bill of Materials
Figure 4. Bottom Layer
Table 2 lists materials required for the EVM.
Table 2. Bill of Materials
Item
bq24018 Ref Des Description Size MFR Part Number
Number
1 0 C1 Capacitor, ceramic, X5R, 1 μ F, 10 V 805 Panasonic ECJ-2YB1A105K
2 1 C2 Capacitor, ceramic, X5R, 1 μ F, 10 V 805 Panasonic ECJ-2YB1A105K
3 1 C3 Capacitor, ceramic, X7R, 0.47 μ F, 16 V 805 Panasonic ECJ-2YB1C474K
4 1 D1 Diode, LED, red, 1.8 V, 20 mA, 20 mcd 603 Lite-On 160-1181-1-ND
5 1 D2 Diode, LED, green, 2.1 V, 20 mA, 6 mcd 603 Lite-On 160-1183-1-ND
6 1 J1 Terminal block, 2 pin, 6 A, 3,5 mm 0.27 × 0.25 OST ED1514
7 2 J2, J3 Terminal block, 4 pin, 6 A, 3,5 mm 0.55 × 0.25 OST ED1516
8 2 J4, J5 Header, 3 pin, 100 mil spacing, (36-pin strip) 0.100 × 3 Sullins PTC36SAAN
9 2 R1, R2 Resistor, chip, 1.5 k Ω , 1/16 W, 1% 603 Std Std
10 0 R3 Resistor, chip, 1 M Ω , 1/16 W, 1% 602 Std Std
11 2 R5, R6 Resistor, chip, 10 k Ω , 1/16 W, 1%1 603 Std Std
12 1 R4 Resistor, chip, 1.3 k Ω , 1/16 W, 1% 603 Std Std
13 1 U1 IC, single Li-Ion/Li-Polymer, charge manager MLP10 TI bq24018DRC
14 2 — Shunt, 100-mil, black 0.100 3M 929950-00
15 1 — PCB, bq24018, 1.6 in × 1.3 in × 0.031 in Any HPA261
Notes: 1) These assemblies are ESD sensitive; ESD precautions must be observed.
2) These assemblies must be clean and free from flux and all contaminants. Use of no-clean flux is not acceptable.
3) These assemblies must comply with workmanship standards IPC-A-610 Class 2.
Reference designators marked with an asterisk (**) cannot be replaced by substitutes. All other components can be replaced with equivalent
4)
manufacturer components.
SLUU279 – August 2007 bq24018 (bqTINY™) 7
Submit Documentation Feedback