Datasheet

16
bq2018
Dimension
Millimeters Inches
Min. Max. Min. Max.
A - 1.10 - 0.043
A1 0.05 0.15 0.002 0.006
B 0.18 0.30 0.007 0.012
C 0.09 0.18 0.004 0.007
D 2.90 3.10 0.115 0.122
E 4.30 4.48 0.169 0.176
e 0.65BSC 0.0256BSC
H 6.25 6.50 0.246 0.256
L 0.50 0.70 0.020 0.028
Notes:
1. Controlling dimension: millimeters. Inches shown for reference only.
2 'D' and 'E' do not include mold flash or protrusions. Mold flash or protrusions shall not exceed 0.15mm per side
3 Each lead centerline shall be located within ±0.10mm of its exact true position.
4. Leads shall be coplanar within 0.08mm at the seating plane.
5 Dimension 'B' does not include dambar protrusion. The dambar protrusion(s) shall not cause the lead width
to exceed 'B' maximum by more than 0.08mm.
6 Dimension applies to the flat section of the lead between 0.10mm and 0.25mm from the lead tip.
7 'A1' is defined as the distance from the seating plane to the lowest point of the package body (base plane).
8-Pin TSSOP ~ TS Package Suffix