Datasheet

WRITE ADC
CONTROL Register
WRITE ADC
CONTROL Register
1st Internal
Trigger
2nd Internal
Trigger
1st Conversions,
[SA3:SA0] to [EA3:EA0]
2nd Conversions,
[SA3:SA0] to [EA3:EA0]
SS
MOSI
DAV
1stRoundof
Conversions,
[SA3:SA0]to[EA3:EA0]
InternalTrigger
WRITE ADC
CONTROL Register
2ndRoundof
Conversions,
[SA3:SA0]to[EA3:EA0]
SS
MOSI
DAV
2 sm
1st Trigger
1st Conversions, of
Analog Inputs, From
[SA3:SA0] to [EA3:EA0]
2nd Conversions,
[SA3:SA0] to [EA3:EA0]
Rising Edge
Starts Conversions
2nd Trigger 3rd Trigger
3rd Conversions,
[SA3:SA0] to [EA3:EA0]
CONVERT
DAV
AMC7823
SLAS453F –APRIL 2005–REVISED MARCH 2012 www.ti.com
Figure 42. Internal Trigger, Direct-Mode Figure 43. Internal Trigger, Auto-Mode
Figure 44. External Trigger
Analog Input Out-of-Range Detection (see Analog Input Out-of-Range Alarm Section)
The first four analog inputs of the group defined by the bits [SA3:SA0] and [EA3:EA0] are implemented with out-
of-range detection. When an input is out of the preset range, the corresponding alarm flag, bit ALR-n of the ALR
(Alarm) Register is set. If any of the four inputs are out of range, the global out-of-range pin GALR goes low.
Four GPIO pins (GPIO-0, GPIO-1, GPIO-2 and GPIO-3) can be configured as out-of-range indicators for each of
the first four analog inputs. See the Analog Input Out-of-Range Alarm and Digital I/O sections for more details.
Full-Scale Range of Analog Input
The full-scale range of the analog input is 2 × V
REF
, but must not exceed the supply value AV
DD
. Input saturation
can occur if the analog input exceeds this value.
The internal reference or an externally applied reference may be used as V
REF
. The bit SREF in the AMC
Status/Configuration Register controls the selection of the internal reference. When SREF = '0' (power-up default
condition), the internal reference is selected and is internally applied through a 10kΩ resistor to pin 21. When
SREF = '1', the internal reference is disconnected from pin 21, and an external reference may be applied. See
Figure 48.
Table 4 shows the configuration of the ADC input range.
Table 4. Configuration of ADC Input Range
BIT BIT ADC INPUT
GREF SREF RANGE DESCRIPTION
0 0 0 to 2.5V Internal reference, 1.25V
1 0 0 to 5V Internal reference, 2.5V, AV
DD
= 5V only
Don't External reference V
REF
. 2 × V
REF
must not be greater than AV
DD
.
1 0 to 2 × V
REF
care Set SREF = 1 when applying external reference.
26 Submit Documentation Feedback Copyright © 2005–2012, Texas Instruments Incorporated
Product Folder Link(s): AMC7823