Datasheet

SWITCHING CHARACTERISTICS
ESD PROTECTION
AM26LV31E-EP
www.ti.com ............................................................................................................................................................................................ SLLS947 – NOVEMBER 2008
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP
(1)
MAX UNIT
t
PHL
Propagation delay time, high- to low-level output 4 8 12 ns
See Figure 2
t
PLH
Propagation delay time, low- to high-level output 3.5 8 12 ns
t
t
Transition time (t
r
or t
f
) See Figure 2 5 10 ns
t
PZH
Output-enable time to high level See Figure 3 10 20 ns
t
PZL
Output-enable time to low level See Figure 4 10 20 ns
t
PHZ
Output-disable time from high level See Figure 3 10 20 ns
t
PLZ
Output-disable time from low level See Figure 4 10 20 ns
t
sk(p)
Pulse skew 0.5 3 ns
t
sk(o)
Skew limit (pin to pin) See Figure 2
(2) (3)
1.5 ns
t
sk(lim)
Skew limit (device to device) 3 ns
f
(max)
Maximum operating frequency See Figure 2 32 MHz
(1) All typical values are at V
CC
= 3.3 V, T
A
= 25 ° C.
(2) Pulse skew is defined as the |t
PLH
– t
PHL
| of each channel of the same device.
(3) Skew limit (device to device) is the maximum difference in propagation delay times between any two channels of any two devices.
PARAMETER TEST CONDITIONS TYP UNIT
HBM ± 15
Driver output IEC61000-4-2, Air-Gap Discharge ± 15 kV
IEC61000-4-2, Contact Discharge ± 8
Copyright © 2008, Texas Instruments Incorporated Submit Documentation Feedback 5
Product Folder Link(s): AM26LV31E-EP