Datasheet

Hardware Setup, CW Mode www.ti.com
9.2 Step 2: Apply Input and Observe Outputs
• Apply an analog signal (2.51 M, –10 dBm) to any analog input SMA.
• The CW outputs (J12, J13) display the frequency I and Q signals at 10 kHz as shown in Figure 21.
The GUI Gain Control Feedback Resistor can be used to vary the amplitude of the outputs.
Figure 21. CW Outputs
22
AFE5809EVM Evaluation Module SLOU338A–October 2012–Revised November 2012
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated