Datasheet

C155

C49

C154

C156

C157

C53

www.ti.com

Hardware Setup, CW Mode

9.3 External Clock for CW Mode

The CW mode clocks can be supplied from J9 (X16/X8/X4/X1) and J10 (X1) using external signal

generators. The manufacture default setup uses ON BOARD CLOCK, with which C154, C155, C156, and

C157 are installed. To switch to an external clock, these four capacitors must be uninstalled and

capacitors C49,C50,C52, and C53 must be installed. Table 1 shows the configuration for these eight

capacitors.

Table 1. Configuration for Clock Capacitors

Capacitor Onboard Clock External Clock Comments

C49 Uninstalled Installed Top layer of the EVM

C50 Uninstalled Installed Bottom layer of the EVM

C52 Uninstalled Installed Bottom layer of the EVM

C53 Uninstalled Installed Top layer of the EVM

C154 Installed Uninstalled Top layer of the EVM

C155 Installed Uninstalled Top layer of the EVM

C156 Installed Uninstalled Top layer of the EVM

C157 Installed Uninstalled Top layer of the EVM

Figure 7. Relevant Capacitors for CW Mode, Top Side

SLOU328A– November 2011– Revised December 2011 AFE5808/08AEVM (Rev E) Evaluation Module

Submit Documentation Feedback