Datasheet

Hardware Setup, CW Mode www.ti.com
9.2 Step 2: Apply input and observe outputs.
• Apply an analog signal (2.51 M, –10 dBm) to any analog input SMA.
• The CW outputs (J12, J13) display the frequency I and Q signals at 10 kHz as shown in Figure 6. The
GUI Gain Control Feedback Resistor can be used to vary the amplitude of the outputs.
Figure 6. CW Outputs
14
AFE5808/08AEVM (Rev E) Evaluation Module SLOU328A– November 2011– Revised December 2011
Submit Documentation Feedback
Copyright © 2011, Texas Instruments Incorporated