Datasheet

www.ti.com

Hardware Setup, CW Mode

9.1 Step 1: Switch to CW Mode.

• Go to the CW Mode page.

• Check CW Mode Enable. The LED41, LED42, and LED43 on AFE5808/08AEVM all illuminate.

• Select 500ohms for the gain control feedback resistor.

Figure 5. Switching From Default (ADC) Mode Panel to CW Mode Panel

SLOU328A– November 2011– Revised December 2011 AFE5808/08AEVM (Rev E) Evaluation Module

Submit Documentation Feedback