Datasheet

www.ti.com Hardware Setup, CW Mode
9.2 Step 2: Apply input and observe outputs.
• Apply an analog signal (2.51 M, –10 dBm) to any analog input SMA.
• The CW outputs (J12, J13) display the frequency I and Q signals at 10 kHz as shown in Figure 6. The
GUI Gain Control Feedback Resistor can be used to vary the amplitude of the outputs.
Figure 6. CW Outputs
15
SLOU329A– November 2011– Revised December 2011 AFE5807EVM (Rev E) Evaluation Module
Submit Documentation Feedback
Copyright © 2011, Texas Instruments Incorporated