Datasheet

Hardware Setup, CW Mode www.ti.com
9.1 Step 1: Switch to CW Mode.
• Go to the CW Mode page.
• Check CW Mode Enable. The LED41, LED42, and LED43 on AFE5807EVM all illuminate.
• Select 500 Ω for the gain control feedback resistor.
Figure 5. Switching From Default (ADC) Mode Panel to CW Mode Panel
14
AFE5807EVM (Rev E) Evaluation Module SLOU329A– November 2011– Revised December 2011
Submit Documentation Feedback
Copyright © 2011, Texas Instruments Incorporated