Datasheet

www.ti.com
AFE44x0SPO2EVM FAQs
9 AFE44x0SPO2EVM FAQs
9.1 EVM communicating with the PC application
A quick and simple check to verify serial register write operation is to put the AFE44x0 in power-down
mode. Follow the sequence to check if the GUI is communicating with the EVM.
In Device ConfigurationGlobal Settings tab, select Powerdown_AFE
This powers down the AFE and the VCM output voltage of the AFE drops to 0 V
VCM is measured at the VCM_AFE serial jumper resistor R28 on the board
9.2 ADC_RDY signal
After executing the GUI, observe the ADC_RDY waveform at series jumper resistor R26.This should be at
the same frequency as the PRF. Figure 39 shows the ADC_RDY waveform at 500-Hz PRF.
Figure 39. ADC_RDY Waveform at 500-Hz PRF
35
SLAU480AJanuary 2013Revised February 2013 AFE4400 and AFE4490 Development Guide
Submit Documentation Feedback
Copyright © 2013, Texas Instruments Incorporated