Datasheet

www.ti.com

Appendix E

Table 2. Error Code Definitions (continued)

Error Code Error # Description Most Probable Cause Possible Action

SENSE_RES_CAL_LOW 65571 Sense resistor value too Sensor Resistor Hardware Verify Sense Resistor Value,

low in post cal checks Failure, Connection Problem, check current supply

Setting Problem, or HPA169 connections, and verify VTI and

Power Supply Problem Configuration Settings. Try

increasing tolerances if possible

VOLT_CAL_HIGH 65580 Voltage value too high in Module hardware failure, Verify Voltage circuit, voltage

post cal checks HPA169 Voltage power power supply, VTI, and

supply problem or Configuration Settings. Try

Configuration failure increasing tolerances if possible

VOLT_CAL_LOW 65581 Voltage value too low in Module hardware failure, Verify Voltage circuit, voltage

post cal checks HPA169 Voltage power power supply, VTI, and

supply problem or Configuration Settings. Try

Configuration failure increasing tolerances if possible

TEMP_CAL_HIGH 65590 Temperature value too Module hardware failure, Verify VTI settings, and

high in post cal checks HPA169 Temperature sensor Temperature sensor location

Failure

TEMP_CAL_LOW 65591 Temperature value too low Module hardware failure, Verify VTI settings, and

in post cal checks HPA169 Temperature sensor Temperature sensor location

Failure

SEAL_CMD_FAILED 65610 Seal command failed Communication Failure Check Connections. Verify

version compatibility between

bqMTester softare and Module

under Test.

ERR_READ_CB_INT_TEMP_SENSOR 65611 Error reading internal Temperature sensor failure Verify HPA169 calibration

temperature sensor on board temperature sensor

HPA169 calibration board connections or replace sensor

ERR_READ_CB_EXT_TEMP_SENSOR 65612 Error reading external Temperature sensor failure Verify HPA169 calibration

temperature sensor on board temperature sensor

HPA169 calibration board connections or replace sensor

ERR_CALIBRATION_OUTOFSPEC 65613 Time to recalibrate VTI calibration Timer expired. Calibrate VTI settings

HPA169 calibration board

ERR_TEST_ROUTINE 65614 Reserved

ERR_WRITEDATE_FAILED 65546 Failed to write date Data Flash Failure Module Repair/Retry Test

ERR_WORKAROUND_ROUTINE 65614 GG mode work around Board offset has too much Calibrate board offset

failure variance.

ERR_BOARD_OFFSET_LIMIT 65615 Board offset outside of Board offset has too much Calibrate board offset

limits variance.

ERR_BOARD_OFFSET_TIMEOUT 65616

SLUU397A– February 2011– Revised May 2011 Error Code Definitions

Submit Documentation Feedback