Datasheet

www.ti.com

Advanced bqMTester Instructions

If only one temperature probe is required for all channels, and it is to be an external temperature sensor

and not the one installed on the calibration board for a station named Station1, you would do the following:

1. Start the StationSetup.exe program.

2. Unlock and click Search for boards.

3. Name all of the stations using a unique Station ID but name one station Station1 so that it can be

referenced in the next couple of steps.

4. Select the Ext. Temp Probe checkbox for Station1. All other stations select On Board Temp Probe.

5. Select the Use for Test checkbox for Station1 and all other stations.

6. Click Save and Proceed.

7. On the Temperature Probe Selection screen, select External Probe: Station1 for all the stations

available in the list.

8. Click Next.

9. Configure the global screen as described in Section 4.6.

Now all stations will use the probe connected to the External Temperature Probe Terminal Block for the

station named Station1.

4.6 Global Configuration Window

Clicking the Next button from the Temperature Probe Selection window brings up the Global

Configuration window, as shown in Figure 6. Here, all data that is Global to all stations connected to the

PC can be configured. All numeric values are specified in signed decimal except for the serial number

field, which is unsigned with a max value of 65535.

NOTE: If you do not select items such as CC Offset Calibration, Temperature Calibration,

Voltage Calibration, or Pack Current Calibration, the respective frames in this window are

grayed out for ease of use.

SLUU397A– February 2011– Revised May 2011 Advanced bqMTester

Submit Documentation Feedback