Datasheet

6.2 Setting Up the MSOP-8EVM-PDK
www.ti.com MSOP-8EVM-PDK Kit Operation
The MSOP-8EVM-PDK contains both the MSOP-8EVM and the MMB0 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the MSOP-8EVM-PDK:
Step 1. Unpack the MSOP-8EVM-PDK kit.
Step 2. Set the jumpers and switches on the MMB0 as shown in Figure 2 .
a. Set the Boot Mode switch to USB.
b. Connect +5V and +5VA on jumper block J13 (if +5V is supplied from J14 +5VA).
c. Leave +5V and +VA disconnected on jumper block J13.
d. If the PDK will be powered from an ac adapter, and used in unipolar mode, connect J12. If
the PDK will be powered through the terminal block or will be used in bipolar mode,
disconnect J12.
Figure 2. MMB0 Initial Setup
Step 3. Set the jumpers on the MSOP-8 EVM board as shown in Figure 3 (note that these jumpers
are the factory-configured settings for the MSOP-8 EVM):
a. Set I/O Voltage jumper block JMP3 as shown in Figure 3 .
b. Set the reference source select jumpers (JMP5 and JMP6) to the onboard/BUF positions.
c. Set the CS/SHDN source select jumper (JMP2) to the FS position.
d. Set up VCC jumper block JMP1 as shown in Figure 3 .
SBAU140 – December 2008 MSOP-8EVM and MSOP-8EVM-PDK 9
Submit Documentation Feedback