Datasheet

www.ti.com

EVM Setup

2.2 ADS8028EVM-PDK Kit Operation

To prepare to evaluate the ADS8028 with the ADS8028EVM-PDK, complete the following steps:

1. Verify the ADS8028EVM jumper settings from the factory as shown in Figure 2 and also listed in

Table 3.

2. Install ADCPro and the ADS8028EVM plug-in software. Complete hardware connections and driver

installation as per the ADCPro HW/SW Installation Manual. Use the following jumper settings on the

MMB0 to configure power with the ac adapter.

• MMB0 J12 → Short (power supplied to the MMB0 through MMB0 J2 jack)

• MMB0 J13A → Open (+VA supply is not used on the ADS8028EVM)

• MMB0 J13B → Short (power supplied to the ADS8028EVM through the MMB0 J5 header)

• No additional power connections are required

3. Plug the ADS8028EVM onto the MMB0 motherboard. The female portion of J-ANALOG, J-DIGITAL,

and J-POWER on the bottom of the EVM align with male connectors J7, J4, and J5 (respectively) on

the MMB0.

4. Connect the included USB cable to J1 on the MMB0 and to an unused USB port on the computer with

ADCPro installed.

5. Connect the included ac adapter to the MMB0.

SBAU198–April 2012 ADS8028EVM-PDK

Submit Documentation Feedback