Datasheet

ADS7953EVM-PDK Kit Operation

www.ti.com

Figure 17. Install New Driver Wizard Screen 5

4. Once Windows finishes installing the software driver, the plug-in downloads the firmware to the MMB0.

The status area will display Connected to EVM when the device is connected and ready to use. If the

firmware does not load properly, try resetting the MMB0 by pressing reset and then reloading the

plug-in.

5. Verify the proper installation of the USBStyx driver using the Device Manager. Note that the first driver

item, NI-VISA USB Devices, will disappear and a new item, LibUSB-Win32 Devices will appear, as

Figure 18 shows.

Figure 18. USBSytx Driver Verification Using Device Manager

The driver installation wizard sequence should not appear again, unless the board is connected to a

different USB port.

ADS79xxEVM and ADS79xxEVM-PDK SLAU262C– January 2009– Revised May 2011

Submit Documentation Feedback