Datasheet

www.ti.com Appendix: Setting Up the ADS7924EVM-PDK
3. Plug the ADS7924EVM into the MMB3 as Figure 21 illustrates.
Figure 21. Connecting ADS7924EVM to MMB3
CAUTION
Do not misalign the pins when plugging the ADS7924EVM into the MMB3.
Check the pin alignment carefully before applying power to the PDK.
Step 3. Set the jumpers and switches on the ADS7924EVM as shown in Figure 3 (note that these
settings are the factory-configured settings for the EVM).
Once this is completed, then load the ADS7924EVM plug-in and follow the instructions (refer to
Section 7.3) to load the firmware.
23
SBAU173–June 2010 ADS7924EVM and ADS7924EVM-PDK User's Guide
Copyright © 2010, Texas Instruments Incorporated