Datasheet
www.ti.com
PIN CONFIGURATION (LVDS MODE)
PDN
DRVDD
AGND
INP
CLKOUTM
INM
CLKOUTP
AGND
AVDD
AVDD
AGND
CLKP
CLKM
1
2
3
4
5
6
7
8
9
10
1
1
12
13
14
15
16
D10_D1
1_P
D10_D11_M
NC
D8_D9_P
NC
D8_D9_M
D6_D7_P
D6_D7_M
RESET
D4_D5_P
SCLK
D4_D5_M
SDATA
D2_D3_P
SEN
D2_D3_M
D0_D1_P
D0_D1_M
24
23
22
21
20
19
18
17
31
30
29
28
27
26
25
BottomPadConnected
ToDRGND
32
VCM
ADS6125, ADS6124
ADS6123, ADS6122
SLAS560A – OCTOBER 2007 – REVISED MARCH 2008
RHB PACKAGE
(TOP VIEW)
Figure 8. LVDS Mode Pinout
Table 14. Pin Assignments – LVDS Mode
PIN PIN NUMBER
PIN NAME DESCRIPTION
TYPE NUMBER OF PINS
AVDD Analog power supply I 13, 15 2
AGND Analog ground I 6, 9, 12 3
CLKP, CLKM Differential clock input I 7, 8 2
INP, INM Differential analog input I 10, 11 2
Internal reference mode – common-mode voltage output.
VCM External reference mode – reference input. The voltage forced on this pin sets the I/O 14 1
internal references.
Serial interface RESET input.
When using the serial interface mode, the user MUST initialize internal registers
through hardware RESET by applying a high-going pulse on this pin, or by using the
RESET software reset option. See the SERIAL INTERFACE section. I 2 1
In parallel interface mode, the user has to tie the RESET pin permanently HIGH.
(SCLK, SDATA and SEN are used as parallel pin controls in this mode)
The pin has an internal 100-k Ω pull-down resistor.
This pin functions as serial interface clock input when RESET is low.
When RESET is tied high, it controls the coarse gain and internal/external reference
SCLK selection. Tie SCLK to low for internal reference and 0 dB gain and high for internal I 3 1
reference and 3.5 dB gain. See Table 1 .
The pin has an internal 100-k Ω pull-down resistor.
This pin functions as serial interface data input when RESET is low. It controls
various power down modes along with PDN pin when RESET is tied high.
SDATA I 4 1
See Table 3 for detailed information.
The pin has an internal 100 k Ω pull-down resistor.
This pin functions as serial interface enable input when RESET is low. When RESET
SEN is high, it controls output interface type and data formats. See Table 2 for detailed I 5 1
information. The pin has an internal 100-k Ω pull-up resistor to DRVDD.
PDN Global power down control pin I 16 1
Copyright © 2007 – 2008, Texas Instruments Incorporated Submit Documentation Feedback 23
Product Folder Link(s): ADS6125, ADS6124 ADS6123, ADS6122