Datasheet

www.ti.com
Software Control
2 Software Control
2.1 Installation Instructions
Open the ADS58H40_Installer_vxpx folder (xpx represents the latest version, which is 2.0 at the time
of this writing)
Run Setup.exe
Follow the on-screen instructions
Once installed, launch by clicking on the ADS58H40_GUI_vxpx program in Start All Programs
Texas Instruments ADCs
When plugging in the USB cable for the first time, the Found-New-Hardware-Wizard prompts to install
the USB drivers
When a pop-up screen opens, select Continue Downloading
Follow the on-screen instructions to install the USB drivers
If needed, access the drivers directly in the install directory
2.2 Software Operation
The ADS58H40 EVM GUI is compatible for both ADS58H40 and ADS58H43 EVMs. The software allows
programming control of the ADS58H4x device. The front panel provides a tab for common control of the
ADS58H4x and a SNRBoost/Burst Mode tab for control of the special data capture modes. The GUI tabs
provide a convenient and simplified interface to the most-used registers of each device.
7
SLAU455AAugust 2012Revised October 2012 ADS58H4x (ADS58H40/ADS58H43) EVM
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated