Datasheet

J14

USB1

J15

J11

J13

J12

J10

J16

JP5

JP6

JP4

TP2

TP_VP

Board Configuration

www.ti.com

9 Board Configuration

9.1 Input/Output, Power Supply, and USB

Figure 11. I/O, PWR, and USB Connector

Table 1. Input/Output, Power, and USB

Connector Description

J6,J7,J10….J15 Analog Input signals for Ch1-Ch8. Connect to a signal generator. A band-pass filter must be applied between

the generator and the SMA to get a better result. (See Figure 3)

J16 It is an alternative input for channel 8. Need to install two resistors (R169 and R170) and remove two

resistors(R171 and R172) from J6.

P1/TP_VP P1 is the +5-V power supply connector. TP_VP is the test point for +5-V power supply.

JP4 Onboard 3.3-V Analog enables. Set up as Figure 2 is a must to use onboard 3.3 V

JP5 Onboard 1.8-V Digital enables. Set up as Figure 2 is a must to use onboard 1.8 V

JP6 Onboard 1.8-V Analog enables. Set up as Figure 2 is a must to use onboard 1.8 V

TP1, TP2, TP3, Ground test points.

TP4, TP5, TP14,

TP21, TP23,

TP25, TP34,

USB1 USB interface connector

ADS5292, 8-Channel, Analog-to-Digital Converter Evaluation Module SLAU377–October 2011

Submit Documentation Feedback