Datasheet

ADS4126

ADS4129

ADS4146

ADS4149

www.ti.com

SBAS483G – NOVEMBER 2009–REVISED JANUARY 2011

7 6 5 4 3 2 1 0

DIS LOW

CLKOUT FALL CTRL 0 0 STBY 0 0

LATENCY

Bits[7:6] CLKOUT FALL CTRL

Controls position of output clock falling edge

LVDS interface:

00 = Default position (timings are specified in this condition)

01 = Setup reduces by 400ps, hold increases by 400ps

10 = Data transition is aligned with rising edge

11 = Setup reduces by 200ps, hold increases by 200ps

CMOS interface:

00 = Default position (timings are specified in this condition)

01 = Falling edge is advanced by 100ps

10 = Falling edge is advanced by 200ps

11 = Falling edge is advanced by 1.5ns

Bits[5:4] Always write '0'

Bit 3 DIS LOW LATENCY: Disable low latency

This bit disables low-latency mode,

0 = Low latency mode is enabled. Digital functions such as gain, test patterns and offset correction

are disabled

1 = Low-latency mode is disabled. This setting enables the digital functions. See the Digital

Functions and Low Latency Mode section.

Bit 2 STBY: Standby mode

This bit sets the standby mode.

0 = Normal operation

1 = Only the ADC and output buffers are powered down; internal reference is active; wake-up time

from standby is fast

Bits[1:0] Always write '0'

Product Folder Link(s): ADS4126 ADS4129 ADS4146 ADS4149