Datasheet

11.1.2 Connecting a Laboratory Power Supply
About the MMB0 www.ti.com
A laboratory power supply can be connected through terminal block J14 on the MMB0, as shown in
Figure 12 .
To use a unipolar lab power supply configuration:
• Disconnect J12 on the MMB0.
• Connect a +5V dc supply to the +5VD terminal on J14.
• Connect ground of the dc supply to the GND terminal on J14.
It is not necessary to connect a +5V dc supply voltage to the +5VA terminal on J14 if the +5V/+5VA
position on J13 is shorted.
Figure 12. Laboratory Power-Supply Connection
ADS1672EVM and ADS1672EVM-PDK User's Guide16 SBAU147 – March 2009
Submit Documentation Feedback