Datasheet

10.2 Setting Up the ADS1672EVM-PDK
www.ti.com ADS1672EVM-PDK Kit Operation
The ADS1672EVM-PDK contains both the ADS1672EVM and the MMB0 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the ADS1672EVM-PDK:
Step 1. Unpack the ADS1672EVM-PDK kit.
Step 2. Set the jumpers and switches on the MMB0 as shown in Figure 9 .
• Set the Boot Mode switch to USB.
• Connect +5V and +5VA on jumper block J13 (if +5V is supplied from J14 +5VA).
• Leave +5V and +VA disconnected on jumper block J13.
• If the PDK will be powered from an ac adapter, connect J12. If the PDK will be powered
through the terminal block, disconnect J12. See Section 9.3 for details on connecting the
power supply.
Figure 9. MMB0 Initial Setup
SBAU147 – March 2009 ADS1672EVM and ADS1672EVM-PDK User's Guide 13
Submit Documentation Feedback