Datasheet

ADS1256EVM-PDK Kit Operation

www.ti.com

space

Step 3. Plug the ADS1256EVM into the MMB0.

CAUTION

Do not misalign the pins when plugging the ADS1256EVM into the MMB0.

Check the pin alignment carefully before applying power to the PDK.

Step 4. Set the jumpers and switches on the ADS1256EVM as shown in Figure 13 (note that these

settings are the factory-configured settings for the EVM):

• Set jumper block J4 as shown in Figure 7.

• Set the reference source select switches S1 and S2 to the center position.

• Set up jumper block J3 as shown; refer to Figure 7.

Figure 13. Connecting the ADS1256EVM to the MMB0

ADS1256EVM and ADS1256EVM-PDK SBAU090C–November 2003–Revised July 2010