Datasheet

www.ti.com ADS1248EVM-PDK Kit Operation
Figure 7. Connecting ADS1248EVM to MMB3
CAUTION
Do not misalign the pins when plugging the ADS1248EVM into the MMB3.
Check the pin alignment carefully before applying power to the PDK.
Step 4. Set the jumpers and switches on the ADS1248EVM as shown in Figure 3 (note that these
settings are the factory-configured settings for the EVM).
8.2.1 About the MMB3
The MMB3 is a Modular EVM System motherboard. It is designed around the MSP430F449, a low-power
microcontroller from Texas Instruments. Figure 8 shows a block diagram of the MMB3.
11
SBAU142B– April 2009–Revised May 2011 ADS1148EVM, ADS1248EVM, ADS1148EVM-PDK, and ADS1248EVM-PDK
Submit Documentation Feedback
Copyright © 2009–2011, Texas Instruments Incorporated