Datasheet

www.ti.com

ADS1258EVM-PDK Kit Operation

Figure 19. Install New Driver Wizard Screen 5

5. Once Windows finishes installing the software driver, the plug-in downloads the firmware to the MMB0.

The status area will display Connected to EVM when the device is connected and ready to use. If the

firmware does not load properly, you can try resetting the MMB0 by pressing reset and then reloading

the plug-in.

6. You can verify the proper installation of the USBStyx driver using the Device Manager. Note that the

first driver item, NI-VISA USB Devices, will disappear and a new item, LibUSB-Win32 Devices will

appear, as Figure 20 shows.

Figure 20. USBSytx Driver Verification Using Device Manager

The driver installation wizard sequence should not appear again, unless you connect the board to a

different USB port.

SBAU126C– May 2007– Revised May 2011 ADS1158EVM, ADS1258EVM, ADS1158EVM-PDK, and ADS1258EVM-PDK

Submit Documentation Feedback