Datasheet

www.ti.com

ADS1258EVM-PDK Kit Operation

3. Plug the ADS1258EVM into the MMB0, as shown in Figure 5.

Figure 5. Connecting the ADS1258EVM to the MMB0

CAUTION

Do not misalign the pins when plugging the ADS1258EVM into the MMB0.

Check the pin alignment carefully before applying power to the PDK.

Step 3. Set the jumpers and switches on the ADS1258EVM as illustrated in Figure 3 (note that these

settings are the factory-configured settings for the EVM):

• Set jumper block J4 as illustrated in Figure 3.

• Set the reference source select switches S1 and S2 to the center position.

• Set up jumper block J3 as illustrated in Figure 3.

8.3 About the MMB0

The MMB0 is a Modular EVM System motherboard. It is designed around the TMS320VC5507, a DSP

from Texas Instruments that has an onboard USB interface. The MMB0 also has 16MB of SDRAM

installed.

The MMB0 is not sold as a DSP development board, and it is not available separately. TI cannot offer

support for the MMB0 except as part of an EVM kit. For schematics or other information about the MMB0,

contact Texas Instruments.

SBAU126C– May 2007– Revised May 2011 ADS1158EVM, ADS1258EVM, ADS1158EVM-PDK, and ADS1258EVM-PDK

Submit Documentation Feedback