Datasheet

J13

POWER

SUPPLY

CONFIG

BOOTMODESWITCH

J12

WALLSUPPLYCONNECTION

CONNECTIFNEEDED.

SEE TEXT.

ADS1258EVM-PDK Kit Operation

www.ti.com

8.2 Setting Up the ADS1258EVM-PDK

The ADS1258EVM-PDK contains both the ADS1258EVM and the MMB0 motherboard; however, the

devices are shipped unconnected. Follow these steps to set up the ADS1258EVM-PDK:

Step 1. Unpack the ADS1258EVM-PDK kit.

Step 2. Set the jumpers and switches on the MMB0 as shown in Figure 4:

• Set the Boot Mode switch to USB.

• Connect +5V and +5VA on jumper block J13 (if +5V is supplied from +5VA).

• Leave +5V and +VA disconnected on jumper block J13.

• If the PDK will be powered from an ac adapter, and used in unipolar mode, connect J12.

If the PDK will be powered through the terminal block or will be used in bipolar mode,

disconnect J12. (See Section 8.4 for details on connecting the power supply.)

Figure 4. MMB0 Initial Setup

ADS1158EVM, ADS1258EVM, ADS1158EVM-PDK, and ADS1258EVM-PDK SBAU126C– May 2007– Revised May 2011

Submit Documentation Feedback