User's Manual

9
9. The Software Toolbar
Frequently used commands are implemented into the toolbar at the top of the Host
Software window.
S6400 Utility Software Toolbar
The “Go” button is used to execute the selected command.
To continuously execute a command, select the “Poll” button prior to clicking
“Go.” The “Poll” (continuous) option will remain activated until it is “Stopped.”
Clicking the “Version” button will cause the reader version, serial number, and
reader firmware version to be displayed.
Clicking the “Setup” button causes the baud rate, LED status, audio status, RF
transmitter status, and Wiegand status to be displayed.
The “Reset” button initializes the reader in a manner similar to cycling power. It
resets specific parameters, but leaves some customizable parameters untouched. If
ever a command is issued that causes the reader to stop responding, try clicking the
“Reset” button.
Clicking the “Self Run” button brings up the Self-Run window.
Self-Run Mode Window
When placed in the default Self-Run mode, the unit outputs card data over the
Wiegand data lines. The default setting is “ISO 15693 Card Data”. Selecting a
* Information submitted for FCC, Industry Canada,
RTTE, CE & ETL certification: A92ACS6410 &
A92ACS6420 *