User Manual

62 Using Press-to-Test
Using Press-to-Test
Use Press-to-Test to manage exams using TI graphing calculators in your classroom.
Setting Up Test Mode
1. Turn the calculator OFF.
2. Press and hold down the ~, |, and É keys, and then release.
3. Press OK on each screen to place calculator in exam mode.
4. Exam LED will blink green.
5. The RESET OPTIONS screen displays.
Notes:
• The status bar is blue when in TEST MODE and TEST MODE ENABLED.
• Pic & Image Vars are disabled.
• Calculator data (Vars) are deleted from RAM and Arc.
• By default:
- ANGLE is set to DEGREE
- STAT DIAGNOSTICS is set to ON
- DISABLE logBASE and DISABLE Σ(are set to YES.
6. To change the default settings, move the cursor over the desired setting and press
Í.