User's Manual

Terminal Technician Using the E.S.P. Unit Communicator Program
BIB TRACK ESP Unit User Guide3.doc 09/02/02 Page 7 of 70
Uploading Data from E.S.P. Unit
Use this procedure to transfer data collected by the E.S.P. Unit to your BIB TRACK
computer and then to the Michelin servers.
NOTE: You should perform this procedure as often as possible so that Pressure
Warnings data is kept current. It is recommended that you perform these steps
after every vehicle inspection.
1. At the BIB TRACK computer, click the Communicator icon to start the program.
2. Place the E.S.P. Unit in its Cradle, which is connected to the BIB TRACK
computer.
3. Press the E.S.P. Unit's On/Off key to power up the unit.
4. If you see a menu other than the Main Menu on the E.S.P. Unit's screen, press
the CLR (Clear) key until you see the Main Menu.
MAIN MENU
1: Action Menu
2: Send/Rec Data
3: Erase Data
4: Version
5: Read Sensor
Main Menu
5. Use the Up and Down arrows on the E.S.P. Unit's keypad to highlight item 2:
Send/Receive Data.
6. Press Enter.
7. Turn to the Communicator program on your computer.
8. Click the icon that designates Send Data to BIB TRACK.
9. The Communicator will use on-screen messages to notify you if the data transfer
was successful.