Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B Advanced settings 90
Power save
There are a number of options to save power in the EXPLORER 323. For a general description of
the power save options, see Power mode functions on page 34.
To set up the power save options, do as follows:
1. Under Advanced, select Power control.
2. Select the mode you want to use.
• Always on. This is the default setting. The terminal will never go into power save state
but will always be on when connected to power.
• Idle power save. The terminal will go into power save state after a (configured) period
with no activity. For details, see the next section Idle power save mode.
• Remote on/off. The terminal will go into power save state when the Power control pin
(Remote on/off signal) is inactive. For details, see Remote on/off mode on page 92.
3. Click Save.
Idle power save mode
1. In the Power control page, select Idle power save from the drop-down list.