Installation Manual

Chapter 5: Configuration with web interface
98-169085-B Advanced settings 88
3. Under Trusted IP addresses, click Add IP address and type in the IP address of the
device you want to give access to the terminal.
4. To add more IP addresses, click Add IP address again.
After preparing the terminal and activating the connection you can access the terminal from
one of the trusted IP addresses, using the incoming port defined in the Incoming port field.
• For information on how to prepare the terminal for remote activation of a data
connection, see the next section To set up remote access with SMS.
• For information on how to access the terminal, see To access the terminal from a
remote location on page 37.
If Static IP is included in your airtime subscription, we recommend using this static public IP
address for the terminal in order to provide easy access to the terminal. To use the static IP
address, it must be included in your airtime subscription and you must set the APN source to
SIM default. For details, see To change the APN for a connection package on page 50.
To set up remote access with SMS
1. From the Remote management page, select whether you want to Enable remote
SMS commands.
2. Enter the password for remote SMS. It can be 5 to 15 characters long. The characters 0-9,
a-z and A-Z are allowed. The password is mandatory. This password must be entered
every time you send an SMS command. Default password is remote.
3. Select Trust all phone numbers or, at Trusted phone numbers, enter at least one
trusted mobile number from which the terminal accepts an SMS. Use the wild card * to
accept a range of trusted numbers.
Note
To be able to access the terminal you must have an active data connection.
Note
The terminal must be registered to the satellite services to receive and accept an SMS.
Entered mobile number with wild card Mobile numbers accepted
[phone]* [phone] to [phone]
[phone]* [phone] to [phone]