Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B To set up the interfaces 65
To set up the interfaces
LAN interface setup
1. In the Control panel , click the LAN icon at the top of the page.
2. To enable the LAN interface, select Enable.
3. Click Save.
• A line through a grayed-out LAN icon means the interface is disabled.
• A blue LAN icon means the interface is enabled.
For a description of how to set up the local network parameters, see To set up the
connection mode on page 62 and Advanced LAN on page 68.
WLAN interface setup
To configure the WLAN interface, do as follows:
1. In the Control panel
, click the WLAN icon at the top of the page.
2. To enable the WLAN interface, select Enable.
3. Next to Region, select the region you are located in.
4. Select the Channel number used for communication on the WLAN interface.
5. Select Broadcast SSID to show your WLAN access point to other users.
If you clear the box, your WLAN access point is hidden.
6. Type in the SSID.
Important
If you disable LAN you may not be able to access the EXPLORER 323. Before
disabling the LAN interface, make sure you have a working WLAN
connection.
You can restore the LAN settings with the Reset button, see Reset button on
page 103.
Note
It may take some seconds to enable the interface.
Note
The Internet settings entered in the Terminal settings page also apply for the WLAN
interface. See Internet and LAN connection modes on page 62.
Important
If you disable WLAN you may not be able to access the EXPLORER 323.
Before disabling the WLAN interface, make sure you have a working LAN
connection.
Note
It may take some seconds to enable the interface.
Note
In some countries, the use of WLAN is not allowed. Before continuing, make sure
WLAN is allowed and licensed in the country where you intend to use it.